Understand the correct operation process of the bead cold press

The correct operation process of the bead cold press:

1. Read the operation manual carefully before operating the machine tool.

2. Before the machine tool is connected to the power supply, it must be connected with a firm grounding device.

3. The power cord of the machine tool needs to be connected to a power supply with a protection switch, and check whether the voltage and frequency of the power supply are suitable.

4. Before operating the machine tool, it is necessary to confirm whether the working direction of the motor is correct, otherwise, the wiring direction of the power phase wire must be changed.

5. Before operating the machine tool, check whether the safety protection equipment is normal and whether the components are loose or damaged. Otherwise, it should be adjusted and replaced in time to ensure its normal function. And remember to remove all adjustment tools.

6. When operating the machine tool, wear tight-fitting clothes to prevent wearing loose clothes or wearing ties, watches, bracelets, etc. Those with long hair must wear a work cap to cover their long hair.

7. When the machine is operating, all safety protection equipment cannot be removed or opened privately.

8. When the machine tool is in operation, prevent the operator from leaving the job position.

9. Prevent the processing of workpieces that exceed the original design function of the machine tool and the use of accessories that exceed the design function of the machine tool.

10. Poor physical condition or preventing operation of the machine tool after drinking.

11. The total power supply of the machine tool must be blocked before checking, repairing and feeling clean the machine tool.

12. At the end of the operation of the machine tool, the main power supply must be blocked, and the standby bed can only be separated after intermittent operation.

Precautions and protections when using hydraulic cold press:

1. In the process of using the cold press, pay attention to the various buttons on the machine, especially the three "up", "down" and "emergency switch". They are used under urgent conditions. If there is no special Try to prevent touching the condition.

2. The correct operation of the cold press also includes the daily protection of the cold press, and punctual arrangement. It is necessary to ensure that the upper and lower iron plates are clean and flat to prevent damage to the processed products during the restraint process.

3. Every time when the cold press is operated for restraint, it is necessary to prepare various auxiliary materials in advance to prevent the shortage of materials from forming a pause in the processing, which should not only affect the quality of the cold press restrained products, but also regarding the output power It also constitutes a relative influence.